External Render Systems

Insulated Render Systems

Placing a continuous layer of insulation on the outside of a building provides lower fuel costs through high level of energy efficiency by reducing heat loss through external walls.

 

These lightweight systems reduce the need for costly structural components and are often able to reduce new build construction costs and accelerate build programs.

 

Our huge range of innovative façade systems are available in a variety of colours and textures, used to create a broad range of weather-resistant, decorative and visually pleasing finishes.

 

All our systems have achieved full technical certification and are backed by a comprehensive manufacturer’s warranty which offers a virtual maintenance free façade with a design life in excess of 30 years.

 

Render Only Systems

Our various systems are designed to be applied directly to solid wall, metal or timber frame structures on both new build and refurbishment projects.

 

With a wide range of colours and finishes available, true architectural and aesthetic style can be achieved.

 

Refurbishment and Renovation Projects

Specific criteria for finishes may need to be achieved when contemplating installing onto an existing property.

 

A full survey is essential to establish the individual requirements of each project and allows for detailed discussion based on actual site conditions.

 

Allowing for good planning and preparation to enable a more efficient installation and cost reduction our clients and customers have found this to be an invaluable part of the service we offer.

 

Quality Management and Environmental Management Systems

Recognising the need to adopt sustainable initiatives we operate and maintain strict compliance with ISO 9001:2000 Quality Management Systems and ISO 14001:2004 Environmental Management Systems.

 

Insulated Brick and Stone Cladding Systems

Consists of approx 500 different natural clay brick slips, in a range of sizes, cast in polyurethane under factory controlled conditions.

 

Non load-bearing, lightweight stretcher, stack or flemish bond panels are produced to create approx 1m² sheets’ which can be screwed directly to either masonry, timber or steel frame substrates on site.

 

With a full range of factory-produced or site-applied components to suit external corners, surrounds to window or door openings and any other abutments, the system can cater for most architectural designs.

 

In fact, it could be said that as the system is not load-bearing the limits to use of the system are restricted only by the architect’s imagination.

 

Significantly improve the thermal performance of your building and can reduce a buildings U-value by up to 60%.